04-29-2024, 08:55 PM
Ok. I have hit a "snag".
My first test was just navigation through the map "map1-1.txt". Consisting of 17 images for walls, floor and ceiling. Ran fine.
My second test (map1-2.txt), same map but with added ceiling lights (not obstacle). Total of 33 images. Also ran fine.
Third map (map1-3.txt) using 52 images failed with an error message.
I am obviously doing something wrong... no surprises there... lol It is just that, when it threw up an "index" error, that cloud of confusion crept back in...
Just to determine if it is an "image" or "map" issue, I will go back to either map1-1 or map1-2 and load all 52 images without adding any to the map, save and run... If that is successful then I will add few images to the map until it fails... at least then I will know... This could take a while...
My first test was just navigation through the map "map1-1.txt". Consisting of 17 images for walls, floor and ceiling. Ran fine.
My second test (map1-2.txt), same map but with added ceiling lights (not obstacle). Total of 33 images. Also ran fine.
Third map (map1-3.txt) using 52 images failed with an error message.
I am obviously doing something wrong... no surprises there... lol It is just that, when it threw up an "index" error, that cloud of confusion crept back in...
Just to determine if it is an "image" or "map" issue, I will go back to either map1-1 or map1-2 and load all 52 images without adding any to the map, save and run... If that is successful then I will add few images to the map until it fails... at least then I will know... This could take a while...
Logic is the beginning of wisdom.