Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Wolf3D
#22
I started with the second test program, that successfully ran with 33 images, and all I did was add the remaining 19 images. It ran without error... Then added 5 images to the map. Saved and ran each time before testing. Of course, the first level does not use all 52 images, so I only add those needed to the map. I had almost finished adding the "obstacles" when I noticed that the bushes were different.... But no, I did not change any of the images after defining... grrr...

I will try one more time... I will go back to the "walls only" map and load and add 5 items at a time. Save, Edit and run. etc

I seriously doubt that the problem is with N7 or the N6 RC Editor... In fact, I had just modified the N7 program, to load and run the N6 RC Editor example map and it ran flawlessly... It is obvious that the problem is more than likely, me....

I need more coffee...
Logic is the beginning of wisdom.
Reply


Messages In This Thread
Wolf3D - by johnno56 - 04-23-2024, 10:04 PM
RE: Wolf3D - by 1micha.elok - 04-24-2024, 04:28 AM
RE: Wolf3D - by Marcus - 04-24-2024, 06:37 AM
RE: Wolf3D - by johnno56 - 04-24-2024, 09:24 AM
RE: Wolf3D - by Marcus - 04-24-2024, 04:48 PM
RE: Wolf3D - by johnno56 - 04-24-2024, 11:03 PM
RE: Wolf3D - by johnno56 - 04-25-2024, 12:13 AM
RE: Wolf3D - by 1micha.elok - 04-25-2024, 01:04 AM
RE: Wolf3D - by johnno56 - 04-25-2024, 02:01 AM
RE: Wolf3D - by johnno56 - 04-25-2024, 08:45 AM
RE: Wolf3D - by Marcus - 04-25-2024, 03:34 PM
RE: Wolf3D - by Marcus - 04-25-2024, 09:33 AM
RE: Wolf3D - by johnno56 - 04-25-2024, 10:28 AM
RE: Wolf3D - by Marcus - 04-25-2024, 05:02 PM
RE: Wolf3D - by johnno56 - 04-26-2024, 08:22 AM
RE: Wolf3D - by johnno56 - 04-25-2024, 07:15 PM
RE: Wolf3D - by johnno56 - 04-29-2024, 08:55 PM
RE: Wolf3D - by johnno56 - 04-29-2024, 10:19 PM
RE: Wolf3D - by Marcus - 04-30-2024, 05:24 AM
RE: Wolf3D - by johnno56 - 04-30-2024, 07:11 AM
RE: Wolf3D - by Marcus - 04-30-2024, 02:40 PM
RE: Wolf3D - by johnno56 - 04-30-2024, 07:18 PM
RE: Wolf3D - by 1micha.elok - 05-01-2024, 08:31 AM
RE: Wolf3D - by Marcus - 05-02-2024, 07:15 PM
RE: Wolf3D - by johnno56 - 05-02-2024, 07:57 PM

Forum Jump:


Users browsing this thread: 7 Guest(s)